OrangeRx R615X CPPM

by RCBernDog | June 24, 2014 | (5) Posted in Tips

Single wire connection results in a cleaner build

OrangeRx JR transmitter module on a Turnigy 9X

OrangeRx R615X mounted on a DRQ250

First step go to receiver test

Here you'll see if the channels/inputs are correct

If not go to CPPM settings

These are the channel settings that work the OrangeRx transmitter module and receiver.

What is CPPM?

Combined Pulse Position Modulation (single line connection)

OrangeRx R615X:
http://www.hobbyking.com/hobbyking/store/__46632__OrangeRx_R615X_Spektrum_JR_DSM2_DSMX_Compatible_6Ch_2_4GHz_Receiver_w_CPPM.html

Need help flashing your KK board:

Board: HobbyKing KK2.0
USBasp:
http://www.hobbyking.com/hobbyking/store/__27990__USBasp_AVR_Programming_Device_for_ATMEL_proccessors.html

http://www.ebay.com/itm/like/221461143051?lpid=82
                   
KKMulticopter Flashtool:
http://lazyzero.de/en/modellbau/kkmulticopterflashtool

Thank you and enjoy!

RCBernDog

 

- Find this article & others like it at www.FliteTest.com -

COMMENTS

RCBernDog on August 28, 2014
Yes CPPM makes for clean build. Glad it helped.
Log In to reply
rossmort on August 24, 2014
One thing to note - In my version of firmware on KK2.1 (Not sure on version, but was whatever it came with when it when 2.1 was first released), I had to enable CPPM on one of the other screens. Something to check in case you aren't getting a signal on more than 1 channel. Thanks again for this write-up. Using CPPM cleaned up my build immensely.
Log In to reply
rossmort on August 23, 2014
Wow - I feel quite silly that I have this receive on my Batbone and didn't realize I could do this! It will make things look so much better. Thanks!
Log In to reply
RCBernDog on August 24, 2014
Glad it helped
Log In to reply
enivid on August 24, 2014
Do we know all of the FCs that are compatible with CPPM?
Log In to reply
RCBernDog on August 28, 2014
KK, Naze32, CC3D, Pixhawk...etc
Log In to reply
festaman on April 3, 2015
When using CPPM how do you bind the RX since your powering it from the Bind port.
Log In to reply
camading625 on November 10, 2015
I have a kk2 board and an orange r615x I powered and bound the receiver by powering the throttle first, binding, and then switching to the bind slot for cppm
Log In to reply

You need to log-in to comment on articles.

RCBernDog

(63)

OrangeRx R615X CPPM